| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Super Flo Heads http://woodsbuggy.com/phpBB3/viewtopic.php?f=7&t=10789 |
Page 1 of 1 |
| Author: | turboblue [ Thu Dec 02, 2010 1:22 pm ] |
| Post subject: | Super Flo Heads |
One pair of Super Flo Heads. Just returned from Brothers VW Machine. Bored for 94mm cylinders, 47cc combustion chambers. All new stainless intake and exhaust valves 44x37.5mm. New dual springs, CM retainers and keepers. All head stud washer area and cylinders seating surfaces have been spot faced. Includes valve covers. $750  
|
|
| Author: | fearlessclimber [ Thu Dec 02, 2010 8:23 pm ] |
| Post subject: | Re: Super Flo Heads |
Very, very NICE! Me and Santa have to have a "little talk". |
|
| Author: | davidnashley10 [ Fri Dec 03, 2010 5:48 am ] |
| Post subject: | Re: Super Flo Heads |
fearlessclimber wrote: Very, very NICE! Me and Santa have to have a "little talk". yha thoes good looking heads i got set they said they dont make them nomore |
|
| Author: | smitty [ Fri Dec 03, 2010 12:40 pm ] |
| Post subject: | Re: Super Flo Heads |
are valve guides new and, are covers,long nuts and springs in good shape? |
|
| Author: | hyde [ Fri Dec 03, 2010 8:35 pm ] |
| Post subject: | Re: Super Flo Heads |
davidnashley10 wrote: fearlessclimber wrote: Very, very NICE! Me and Santa have to have a "little talk". yha thoes good looking heads i got set they said they dont make them nomore Drews off road & Davis racing have new sets |
|
| Author: | turboblue [ Sat Dec 04, 2010 11:34 am ] |
| Post subject: | Re: Super Flo Heads |
smitty wrote: are valve guides new and, are covers,long nuts and springs in good shape? I sent them to Brothers and told them to go through them as if they were theirs. The invoice had no parts listed. I'll look Monday and get back to you. I also have an end piece kit for a single carb/turbo engine that works on these heads. Like these only chrome. 
|
|
| Author: | turboblue [ Tue Dec 07, 2010 1:21 pm ] |
| Post subject: | Re: Super Flo Heads |
smitty wrote: are valve guides new and, are covers,long nuts and springs in good shape? I think they replaced one guide. Rest were OK. Valve covers in good shape. Long nuts all there and 2 springs. Just noticed the studs on the heads for the valve covers are missing. I imagine they were removed for machining purposes and didn't get re-installed. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|