i have a swing axle rear end that i dont like.is there a good kit out there for this conversion or should i toss it for another irs rear end
| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| swing axle to irs question http://woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=8261 |
Page 1 of 1 |
| Author: | ridgebuggy [ Sun Dec 13, 2009 12:48 am ] |
| Post subject: | swing axle to irs question |
i have a swing axle rear end that i dont like.is there a good kit out there for this conversion or should i toss it for another irs rear end
|
|
| Author: | A. Cole [ Sun Dec 13, 2009 11:10 am ] |
| Post subject: | Re: swing axle to irs question |
They make an irs pivot that welds in for this conversion. Nearly all buggy shops carry them. Along with that the easiest thing to do with your spring plates is to cut them down. You can do this without removing them from the car. Try and get an irs spring plate to trace/line up before you cut and drill. Then youl will need trailing arms, cv's, axles... |
|
| Author: | A. Cole [ Sun Dec 13, 2009 11:17 am ] |
| Post subject: | Re: swing axle to irs question |
ridgebuggy wrote: i have a swing axle rear end that i dont like.is there a good kit out there for this conversion or should i toss it for another irs rear end You might try and get an irs rear end too. You can usually find them with every thing that you need (arms, cvs, axles, trans (if your going to use sedan). Then you will have all the bolts that you need too. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|