| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Thing spindles Problems... http://woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=15496 |
Page 1 of 1 |
| Author: | jayrod [ Sun Jun 02, 2013 4:35 pm ] |
| Post subject: | Thing spindles Problems... |
well, lower holes in spindle where balljoint goes threw are egged out, balljoint loosened up didn't notice then by the time I addressed the issue the damage was done and tightening things up didn't work for long. So I swear I seen on a website somewhere an insert that you can drill your spindle out and slide that in but cant find it now. So any other ideas? was thinking about taking a balljoint and the spindle to a machine shop and asking what they think . |
|
| Author: | davehix [ Sun Jun 02, 2013 5:35 pm ] |
| Post subject: | Re: Thing spindles Problems... |
Maybe weld it up and get a tapered reamer that size. |
|
| Author: | buggiejunky [ Mon Jun 03, 2013 7:01 am ] |
| Post subject: | Re: Thing spindles Problems... |
that would be too easy dave |
|
| Author: | hpfreak [ Mon Jun 03, 2013 1:58 pm ] |
| Post subject: | Re: Thing spindles Problems... |
jayrod im sure your thinking of a tierod flip kit for a 4x4. it comes with a cone and a reamer to put the tierod on top of the spindle (useless in your case) x2 on welding and reaming i would weld it completely up and drill then ream it. im sure someone can chime in on a ream size for you. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|