Thanks guys, I found a guy with in 5 blocks of my office. Hes been doing cranks for 30 years. The internets a wonderful thing.
| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Crank Balancing http://woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=3371 |
Page 1 of 1 |
| Author: | Odyknuck [ Thu Mar 20, 2008 4:43 pm ] |
| Post subject: | Crank Balancing |
Any body know of any places in northern ohio to get a crank and flywheel balanced? |
|
| Author: | RaceBugg1098 [ Fri Mar 21, 2008 12:10 pm ] |
| Post subject: | |
no but i know a guy down here |
|
| Author: | joeyg1112 [ Fri Mar 21, 2008 5:02 pm ] |
| Post subject: | |
la. products might do it. they're in copley |
|
| Author: | mjb600 [ Fri Mar 21, 2008 5:34 pm ] |
| Post subject: | |
i wouldn't trust la products to do that. I buy all my parts from them but they screwed up rebuilding my cousins carbs and I hear horror stories about what they do to a transmission. i also know a guy that had them rebuild an engine that ran for about an hour then blew up. I like them but i don't trust their work. |
|
| Author: | JeffClay [ Fri Mar 21, 2008 5:41 pm ] |
| Post subject: | |
[quote='mjb600']i wouldn't trust la products to do that. I buy all my parts from them but they screwed up rebuilding my cousins carbs and I hear horror stories about what they do to a transmission. i also know a guy that had them rebuild an engine that ran for about an hour then blew up. I like them but i don't trust their work.[/quote] i second that. messed up my tranny too and i know someone who got a bogus carb job a few years ago. I like them just know what you want when you |
|
| Author: | joeyg1112 [ Fri Mar 21, 2008 5:51 pm ] |
| Post subject: | |
thanks for the info here, i was thinking about letting them do my motor. not now! |
|
| Author: | gkeeton [ Fri Mar 21, 2008 11:51 pm ] |
| Post subject: | |
Jim's Custom VW's in Columbiana can balance it for you. |
|
| Author: | frankenbuggy06 [ Sat Mar 22, 2008 10:25 am ] |
| Post subject: | |
i trust jims for motor work. i just buy parts and tubing from la products. jim is good |
|
| Author: | harleyhunter05 [ Sat Mar 22, 2008 11:42 am ] |
| Post subject: | |
hes done all my machinework on 2 motors, as well as all the guys i ride with -- ive never had a problem with his work--- just his amount of time to get it done. If he tells you a week you can probably figure on at least 3 |
|
| Author: | Odyknuck [ Mon Mar 24, 2008 8:18 pm ] |
| Post subject: | |
Thanks guys, I found a guy with in 5 blocks of my office. Hes been doing cranks for 30 years. The internets a wonderful thing.
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|