WoodsBuggy.com
http://woodsbuggy.com/phpBB3/

Ummm Big problem??
http://woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=14501		 Page 1 of 1
Author:  jayrod [ Sun Dec 16, 2012 7:57 pm ]
Post subject:  Ummm Big problem??
So ive been clearancing my case for the stroker build, crank is all assembled everything clears nicely. Set the cam in to make sure everything is good there, Well the Thrust bearing ( Bearing closest to gear) Doesnt fit onto the cam? Im very confused by this...lol I went double thrust bearings, Is this not compatible with an fk8 or something? The bearing is simply to wide to fit between things..
Author:  MickeyMouse [ Sun Dec 16, 2012 8:01 pm ]
Post subject:  Re: Ummm Big problem??
Just use a hammer. You can fix everything with a hammer. :twisted: :twisted: :shock: :twisted: :twisted:
Author:  jayrod [ Sun Dec 16, 2012 8:10 pm ]
Post subject:  Re: Ummm Big problem??
Lmao :lol: :lol: Crossed my mind!! Not! :wink: I keep thinking Im just young, dumb and over looking something...But its very clear it doesnt fit lol
Author:  jayrod [ Sun Dec 16, 2012 8:19 pm ]
Post subject:  Re: Ummm Big problem??
Ha....got it! there was a itty bitty imperfection on the cam stopping it filed that just a hair and..what do ya know lol It popped right in with a bit more pressure, Suppose I try to be too gentle with things.
Author:  afterburnt [ Sun Dec 16, 2012 8:24 pm ]
Post subject:  Re: Ummm Big problem??
did you try to fit the cam bearing onto the cam out of the motor, what you should do is take a set of calipers and measure the overall width of the cam bearing and the cam journal, and see whats different, and compare some of the measurements to your old cam and bearings
Author:  afterburnt [ Sun Dec 16, 2012 8:26 pm ]
Post subject:  Re: Ummm Big problem??
dam your fast :shock:
Author:  jayrod [ Sun Dec 16, 2012 8:32 pm ]
Post subject:  Re: Ummm Big problem??
haha, Yea I measured everything with calipers the gap was 1.10, the bearing was 1.10 thats when i found the tiny little imperfection.
Author:  jayrod [ Sun Dec 16, 2012 8:51 pm ]
Post subject:  Re: Ummm Big problem??
I dont have any old parts to compare to buddy, The 1915 is staying completely together for a back up :D
Author:  Aaron Creech [ Sun Dec 16, 2012 10:38 pm ]
Post subject:  Re: Ummm Big problem??
You will need to set the end play on the cam. You have to LIGHTLY sand the bearings on a nice flat surface to get the desired clearance. Only do one side of the bearings and make sure you do the same side for both halves. I like about .002"-.003" end play.
Author:  jayrod [ Mon Dec 17, 2012 6:40 am ]
Post subject:  Re: Ummm Big problem??
I was wondering about that , because theres no movement at all . It spins freely but no clearance.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/