| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Free tubing bender program http://woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=7507 |
Page 1 of 1 |
| Author: | Maddog [ Sun Aug 30, 2009 1:36 pm ] |
| Post subject: | Free tubing bender program |
Thought some of you might need this. http://midmoracing.com/bendit.htm If you go here http://www.pirate4x4.com/tech/bendin_tube/index.html read the page and then you will know how to mark your die. |
|
| Author: | Griffin [ Sun Aug 30, 2009 11:20 pm ] |
| Post subject: | Re: Free tubing bender program |
That's cool. Thanks for sharing that. John |
|
| Author: | dragaddict [ Wed Sep 02, 2009 5:26 pm ] |
| Post subject: | Re: Free tubing bender program |
Nice little program. Thanks for sharing! |
|
| Author: | nickschlemer [ Wed Sep 02, 2009 5:41 pm ] |
| Post subject: | Re: Free tubing bender program |
Thanks, nice and simple just what i need. |
|
| Author: | Dave Winterburn [ Mon Nov 09, 2009 3:04 am ] |
| Post subject: | Re: Free tubing bender program |
Thank's. Just tagged those sites 'caus I just got a model 3 as a early birthday- xmas gift. I'll be ordering a die set in the morning. Finally, I can get to the major frame reworking. Most everything else is ready to be bolted or welded on. |
|
| Author: | GuyP [ Fri Nov 27, 2009 1:00 pm ] |
| Post subject: | Re: Free tubing bender program |
When first started twisting tubing I wished I had a program to assist me. But once I found this link and learned how to use it I forgot all about needing a bend program. All you need is a few tools which you should have already and a clean floor to work off of, which in my case I use a sheet of cardboard. Look around their site have a lot of other good tech info. http://www.pirate4x4.com/tech/bendin_tube/index.html |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|