| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| lower engine to tranny stubs http://woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=7368 |
Page 1 of 1 |
| Author: | MickeyMouse [ Sat Aug 08, 2009 9:11 pm ] |
| Post subject: | lower engine to tranny stubs |
I got my engine back today but my lower case stubs are too short to pass through the bell housing since I changed my transmission to a 6 rib. I have checked every store around my house and no one sells 10mm threaded stubs or even threaded rod. I found some that I can order but I was looking for something quicker and wondering what other people have done.. |
|
| Author: | aboone993 [ Sat Aug 08, 2009 9:53 pm ] |
| Post subject: | Re: lower engine to tranny stubs |
I used all thread rod cut it to the length i needed and swapped them out lowes here sells all thread and so does tractor supply I think it it 12 mm but cant swear to that those studs are pretty long can you back the out enough to run it until you get some all thread ? |
|
| Author: | MadMike [ Sat Aug 08, 2009 10:39 pm ] |
| Post subject: | Re: lower engine to tranny stubs |
If you know the length and thread size you'll find them here. http://www.mcmaster.com/#threaded-rods- ... ds/=33ud3v |
|
| Author: | tw9294 [ Sun Aug 09, 2009 9:52 pm ] |
| Post subject: | Re: lower engine to tranny stubs |
Find a bolt long enough and cut the head off then use a nut to clean the threads where u cut the the head off before u install it. |
|
| Author: | MickeyMouse [ Mon Aug 10, 2009 1:29 am ] |
| Post subject: | Re: lower engine to tranny stubs |
Got to love Pull A Part.. Fortunately, there is a Vanagon sitting in a local Pull A Part and I knew that the tranny was already removed. It only took a few minutes to grab the bottom stubs from the engine and I was all set. Came home and installed the engine. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|