| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Remote fill for fuel cell? http://woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=14422 |
Page 1 of 1 |
| Author: | fortydegnorth [ Sat Dec 01, 2012 9:36 pm ] |
| Post subject: | Remote fill for fuel cell? |
I have an RCI aluminum fuel cell in my buggy. I'd like to add a remote fill for it. Anyone have any good ideas aside from buying one of the "fender fill" kits from Jegs or Summit? I think a good piece of hose would be fine but I need a plate at the top side to attach some sort of cap and neck for it. 
|
|
| Author: | gasman [ Sun Dec 02, 2012 11:02 am ] |
| Post subject: | Re: Remote fill for fuel cell? |
Use a muffler clamp u bolt to go around your hose and drill a piece of flat plate or angle to attach it with. Chad 
|
|
| Author: | kvw [ Mon Dec 03, 2012 10:16 pm ] |
| Post subject: | Re: Remote fill for fuel cell? |
Do you have any junk cars around? A factory style fuel fill should have a tab on it and a lip at the hose end. Good Luck Kenric |
|
| Author: | myrddin [ Sun Jan 06, 2013 9:40 pm ] |
| Post subject: | Re: Remote fill for fuel cell? |
I have seen a few like this one you can see half way down the page: http://www.dansperformanceparts.com/buggy/fuel/buggyfuel1.htm I would like to do something like this as well... But I have a round flue cell... So not sure. Tank side http://www.sandparts.com/servlet/the-24688/Fuel-Safe-Remote-Fill/Detail Hope that helps? |
|
| Author: | Orangecrusher [ Wed Mar 20, 2013 11:31 am ] |
| Post subject: | Re: Remote fill for fuel cell? |
Has anyone ever seen a neck extension for the poly tanks. I'm mounting mine lower and it'll be hard to get at it with the pump handle. I've never seen a hose adapter that will fit in the threaded fill on the poly tanks but I figure I'll ask anyway. Ya never know... I should prolly just get a metal tank and be done with it. |
|
| Author: | fortydegnorth [ Wed Mar 20, 2013 11:49 am ] |
| Post subject: | Re: Remote fill for fuel cell? |
I think you just unbolt the entire flange and bolt a new one on. It should have 10 or 12 bolts holding that entire assembly on. |
|
| Author: | Orangecrusher [ Wed Mar 20, 2013 12:40 pm ] |
| Post subject: | Re: Remote fill for fuel cell? |
I apologize I was speaking of the cheap crap poly tanks. After some more research I've decided to upgrade to stainless which I can weld and modify to my liking. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|