Have a new one made. Lots cheaper than buying a new Starret or Brown & Sharpe.jmo
| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Depth Gage Micrometer rods (lufkin) http://woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=13470 |
Page 1 of 1 |
| Author: | myrddin [ Mon Apr 02, 2012 7:19 pm ] |
| Post subject: | Depth Gage Micrometer rods (lufkin) |
Anyone know where I can get a replacement rod? I need a 0-3... |
|
| Author: | GuyP [ Mon Apr 02, 2012 10:18 pm ] |
| Post subject: | Re: Depth Gage Micrometer rods (lufkin) |
I have my Dad's old set. About 25 years ago I bent the 1"-2" rod, we looked all over and couldn't find one back then. Luckily I was able to straighten the one I had. The rods come in 1" increments 0-1",1"-2", 2"-3" and so forth. Other then small shops that repair and calibrate precision tools it may be a tough find. If it were me I'd make one or modify one that's close before I'd give up. Good luck. |
|
| Author: | woogiebugger1 [ Tue Apr 03, 2012 12:39 am ] |
| Post subject: | Re: Depth Gage Micrometer rods (lufkin) |
Have a new one made. Lots cheaper than buying a new Starret or Brown & Sharpe.jmo
|
|
| Author: | myrddin [ Tue Apr 03, 2012 6:54 am ] |
| Post subject: | Re: Depth Gage Micrometer rods (lufkin) |
I did find one of these lastnight... Once it gets in it may do the trick...   This way I should be able to zero it out while its on teh deck height tool and measure from there.. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|