Any cheap suggestions for a front disc brake setup for kingpin front,any junkyard versions
| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Front brakes http://woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=2166 |
Page 1 of 1 |
| Author: | sharpshooter [ Thu Dec 06, 2007 8:56 pm ] |
| Post subject: | Front brakes |
Any cheap suggestions for a front disc brake setup for kingpin front,any junkyard versions
|
|
| Author: | kybuggy1 [ Thu Dec 06, 2007 9:46 pm ] |
| Post subject: | |
Cut off your k/p spuds, weld on some b/j spuds ( can get 'em from Tim,$15 ea.) as far down and back as you can on the spindle. Reinforce the back side of the spindle. Get some used Superbeetle rotors, and some small calipers. Karman ghia's work decent for front. Streetbike calipers work well too, you might have to turn down the rotors real thin, though. Cheapest way I know of. Larry |
|
| Author: | sharpshooter [ Thu Dec 06, 2007 10:00 pm ] |
| Post subject: | |
I would like to find a way without cutting on my combo spindles |
|
| Author: | ncbuggy [ Thu Dec 06, 2007 10:15 pm ] |
| Post subject: | front brakes |
the cheapiest way would be bolt on some drums. if your combo spindles have that three hole bolt pattern. the drums should bolt right on |
|
| Author: | sharpshooter [ Thu Dec 06, 2007 10:17 pm ] |
| Post subject: | |
they have the holes |
|
| Author: | kendel [ Thu Dec 06, 2007 10:26 pm ] |
| Post subject: | brakes |
trade your disc on the parts you really need works for me! 
|
|
| Author: | kendel [ Thu Dec 06, 2007 10:29 pm ] |
| Post subject: | |
tweeds says balljoint backing plates + link pin drums works on there stuff good drums will be fine for the money |
|
| Author: | ncbuggy [ Thu Dec 06, 2007 10:36 pm ] |
| Post subject: | |
I have drum brakes on the front of my chaindrive and there the three bolt pattern like on the combo spindles. with wilwoods on the rear |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|