| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| tubing benders AGAIN!!!!! http://woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=16749 |
Page 1 of 1 |
| Author: | apintonut [ Sun Mar 09, 2014 1:21 am ] |
| Post subject: | tubing benders AGAIN!!!!! |
Ok i was using a borrowed jd2 with every upgrade However I hate to borrow any tool! Some of you will feel me on this. Yes i know 300$ and buy one i just dont have it at this time. Have a hf kinker (its was 40$) I have an idea but wont say no to any one ideas on or help on it http://m.youtube.com/watch?v=xYjH-9Y64to# 
|
|
| Author: | apintonut [ Sun Mar 09, 2014 1:34 am ] |
| Post subject: | Re: tubing benders AGAIN!!!!! |
Problem is the hf bender ram is fixed so i havent had time to figure out the geometry with fixed ram Any opinions on this? Watch vid to get where im trying to go |
|
| Author: | ImmortalSoul219 [ Tue Mar 11, 2014 7:45 pm ] |
| Post subject: | Re: tubing benders AGAIN!!!!! |
Def a cheaper way to make dies. would like to see it work with a jd2 type wrap around bender. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|