| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| CNC Pedal rebuild http://woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=16091 |
Page 1 of 1 |
| Author: | SLOWBRAH [ Tue Oct 01, 2013 5:44 pm ] |
| Post subject: | CNC Pedal rebuild |
My clutch CNC master/pedal needs a rebuild I think. It's not pushing fluid and now sticks after setting empty for a while. It's a 3/4. Know where to get a kit? |
|
| Author: | volksdude2007 [ Tue Oct 01, 2013 5:59 pm ] |
| Post subject: | Re: CNC Pedal rebuild |
Check with the sponsors on woods buggy I'm sure somebody can get them for ya |
|
| Author: | hillaholic [ Tue Oct 01, 2013 6:23 pm ] |
| Post subject: | Re: CNC Pedal rebuild |
I think Passat has the part number to get one from your local parts store. I remember him posting it but I can't find it. It's a $8 wheel cylinder rebuild kit that works in the master if I remember right. Posted using the WoodsBuggy Mobile App |
|
| Author: | hillaholic [ Tue Oct 01, 2013 6:28 pm ] |
| Post subject: | Re: CNC Pedal rebuild |
Found it. 2800passat wrote: and 1 other.... The rod from the pedal to the cylinder needs to be adjusted shorter. If you ever have to rebuild it, go to Auto Zone and get a wheel cyl rebuild kit , part# 66599. it's for 3/4 cups. 2 in each kit. $4. The part # reads upside down is an easy way to remember it. Posted using the WoodsBuggy Mobile App |
|
| Author: | lpb [ Wed Oct 02, 2013 11:26 am ] |
| Post subject: | Re: CNC Pedal rebuild |
before you spend too much time and money on the m/c check the bore. if no good i would replace with wilwood. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|