| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Need help http://woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=13903 |
Page 1 of 1 |
| Author: | NRIbuggys [ Wed Jul 25, 2012 11:43 pm ] |
| Post subject: | Need help |
I flipped my buggy and broke the mount where the trailing arm pivots by the trans. Got a new bracket but don't know how important it is to have it welded back perfect in the same place, any suggestions on how to get it close or perfect??? |
|
| Author: | jesse [ Thu Jul 26, 2012 3:40 am ] |
| Post subject: | Re: Need help |
call joe he cut mine out and put in a whole new one |
|
| Author: | giveitagallon [ Thu Jul 26, 2012 8:00 am ] |
| Post subject: | Re: Need help |
If it was me I would measure side distances and then take a degree finder and c what the good side is at then set the new one at that degree and then tack it . Then ck measurement again and test fit arm . If all good blaze it in . Hope this helps some . |
|
| Author: | NRIbuggys [ Thu Jul 26, 2012 10:04 am ] |
| Post subject: | Re: Need help |
giveitagallon wrote: If it was me I would measure side distances and then take a degree finder and c what the good side is at then set the new one at that degree and then tack it . Then ck measurement again and test fit arm . If all good blaze it in . Hope this helps some . Sounds easy enough, thanks that's what I'll do |
|
| Author: | mudnut [ Thu Jul 26, 2012 11:19 am ] |
| Post subject: | Re: Need help |
just finished doing the same thing to mine. did just like giveitagallon said and all worked out well |
|
| Author: | riverar321 [ Thu Jul 26, 2012 2:55 pm ] |
| Post subject: | Re: Need help |
They also sell gigs or you can make one. Google search "irs pivot jig". |
|
| Author: | kevin f [ Thu Jul 26, 2012 6:27 pm ] |
| Post subject: | Re: Need help |
Call keith mitchell he has a pivot jig he will let you use im sure. We used to build a custom torsion and it worked perfect. |
|
| Author: | NRIbuggys [ Thu Jul 26, 2012 7:16 pm ] |
| Post subject: | Re: Need help |
I'll ask him. He should |
|
| Author: | giveitagallon [ Thu Jul 26, 2012 8:50 pm ] |
| Post subject: | Re: Need help |
Never new they made one , good call ! |
|
| Author: | ridenrace6 [ Thu Jul 26, 2012 11:56 pm ] |
| Post subject: | Re: Need help |
here is a pic of one in use http://www.pacificcustoms.com/AC000155.html |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|