| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| 3 rib in car irs question http://woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=9548 |
Page 1 of 1 |
| Author: | superkingd [ Mon May 24, 2010 7:15 pm ] |
| Post subject: | 3 rib in car irs question |
I'm sure this is a pretty easy one, but I have a 3 rib in a car irs. I also have a lot of spares and just want to make sure I have a set of spare axles. Is it a bus cv on cv end of axle then a car axle and car cv on arm end. And how do I measure to see what is a car and what is a bus cv. Thanks in advance, oh and I could be totally off on all this just let me know, thanks |
|
| Author: | bmoore [ Mon May 24, 2010 7:44 pm ] |
| Post subject: | Re: 3 rib in car irs question |
yes you are rite about which end your cv's go on,if you put a car beside a bus cv its pretty visible that the bus is larger |
|
| Author: | perrib [ Mon May 24, 2010 8:32 pm ] |
| Post subject: | Re: 3 rib in car irs question |
Axles are 15 and 5/8" long. Sway Away part # 2015. |
|
| Author: | superkingd [ Mon May 24, 2010 9:09 pm ] |
| Post subject: | Re: 3 rib in car irs question |
wow where would i be without the internet. Thanks a lot guys |
|
| Author: | turboblue [ Tue May 25, 2010 12:03 pm ] |
| Post subject: | Re: 3 rib in car irs question |
IMHO 15-5/8" are a bit short when the torsion is up on the stops. They are constantly pulling on the cages. I'd rather have the 16-1/4" with long splines for that application. |
|
| Author: | perrib [ Tue May 25, 2010 7:23 pm ] |
| Post subject: | Re: 3 rib in car irs question |
Thanks Gary, I never installed any before. I only knew Sway Away had that size listed. Thats good to know. Purchacing two sets of axles and replacing broken CVs is is an expensive lesson. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|