| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| six rib bell. http://woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=14922 |
Page 1 of 1 |
| Author: | buggybarn [ Thu Feb 21, 2013 9:05 pm ] |
| Post subject: | six rib bell. |
How much do u mill off a six rib bell to fit bug starter? Anyone ever done this . Thanks |
|
| Author: | Red Barron [ Thu Feb 21, 2013 10:56 pm ] |
| Post subject: | Re: six rib bell. |
Get a bus starter! Then when you want to go big AC or WC then you can run the 9" clutch, once you mill about a 1/2" off its gone for good. |
|
| Author: | MickeyMouse [ Fri Feb 22, 2013 6:46 am ] |
| Post subject: | Re: six rib bell. |
I have heard of people running a 3 rib bell housing on a six rib trans but I have never heard of anyone modifying a 6 rib bell housing. If you run a 3 rib bell housing, I believe you will need to cut a little bit off your input shaft. |
|
| Author: | Red Barron [ Fri Feb 22, 2013 10:35 am ] |
| Post subject: | Re: six rib bell. |
MickeyMouse wrote: I have heard of people running a 3 rib bell housing on a six rib trans but I have never heard of anyone modifying a 6 rib bell housing. If you run a 3 rib bell housing, I believe you will need to cut a little bit off your input shaft. Or Swap the input shaft for the 002 input shaft. |
|
| Author: | darrell [ Fri Feb 22, 2013 11:07 am ] |
| Post subject: | Re: six rib bell. |
Just put the 3 rib bell on and your ready to go. Don't need to change anything. |
|
| Author: | turboblue [ Fri Feb 22, 2013 4:42 pm ] |
| Post subject: | Re: six rib bell. |
darrell wrote: Just put the 3 rib bell on and your ready to go. Don't need to change anything. Depends............There are 3 different 3 rib bellhousings. |
|
| Author: | hillaholic [ Fri Feb 22, 2013 5:36 pm ] |
| Post subject: | Re: six rib bell. |
I'm pretty sure you have to remove 1/4" off the starter surface. I don't have a spare 3 rib bell to measure though. |
|
| Author: | hillaholic [ Fri Feb 22, 2013 5:41 pm ] |
| Post subject: | Re: six rib bell. |
just measured my 3rib bell thats in my buggy with a tape measure. It's hard to get an exact measurement but looks close to 2-3/8" from outside bell edge to outside starter edge. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|