WoodsBuggy.com
http://woodsbuggy.com/phpBB3/

091 gear clearance
http://woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=10017		 Page 1 of 1
Author:  jacobnhra [ Wed Aug 04, 2010 6:25 am ]
Post subject:  091 gear clearance
Whats the most optimal 1st and 2nd gear thrust clearance?
Author:  chris38375 [ Wed Aug 04, 2010 10:05 am ]
Post subject:  Re: 091 gear clearance
how do u adjust the clerance between the two 1st gears
Author:  RaceBugg1098 [ Wed Aug 04, 2010 10:21 am ]
Post subject:  Re: 091 gear clearance
I didn't think you could adjust any of the gears, just the pinion depth with those shims
Author:  chris38375 [ Wed Aug 04, 2010 10:31 am ]
Post subject:  Re: 091 gear clearance
thats me i didnt either,the bearings dont move
Author:  jacobnhra [ Fri Aug 06, 2010 6:00 am ]
Post subject:  Re: 091 gear clearance
i was reffering to the amount of end play for each of the individual gears that are on needle bearings.
Author:  chris38375 [ Fri Aug 06, 2010 10:15 am ]
Post subject:  Re: 091 gear clearance
the only shims i know of are behind pinion bearing,theres no way to do what ur talking about,that i know of,
Author:  RaceBugg1098 [ Fri Aug 06, 2010 12:12 pm ]
Post subject:  Re: 091 gear clearance
your refering to the play between the gear and the syncronizer? it should have some slop in it.... thats how I measure it :mrgreen:
Author:  Eric DeBord [ Wed Aug 11, 2010 5:35 am ]
Post subject:  Re: 091 gear clearance
091's do not shim the way type 1's do. The nut has no shims and end play should be ok without any shimming. I would guess .010 to .015 without looking it up. A little more probably will not hurt. I have never had a need to change the end play using either stock or Weddle gears and never had any problems. 3rd and 4th are the ones you usually have trouble with sometimes.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/