| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Master cylinder bore size???? http://woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=9771 |
Page 1 of 1 |
| Author: | MoblMec [ Mon Jun 28, 2010 1:03 pm ] |
| Post subject: | Master cylinder bore size???? |
Hi Guys I have a dule cnc master cyl. pedal set and I have a 3/4 "master ctl. for the rear disk brakes. Will a 5/8" bore cyl. be good for the front that is drum right now but will be changed to disk later on ????? Thanks MoblMec |
|
| Author: | Odyknuck [ Mon Jun 28, 2010 2:49 pm ] |
| Post subject: | Re: Master cylinder bore size???? |
They will be good up until you put disks on front. Then the fronts will get soft. However you could leave the 5/8 bore on the front and have them be soft so that the rears are more biased. Thats what you want anyways. Do the pedals have a balancing bar on them? If so then change out the front master when you put the disks on then adjust accordingly. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|