| WoodsBuggy.com http://woodsbuggy.com/phpBB3/ |
|
| Heading over to the disc side..... http://woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=5829 |
Page 1 of 1 |
| Author: | eggman [ Wed Feb 18, 2009 6:31 pm ] |
| Post subject: | Heading over to the disc side..... |
Ok, here is what I have and what I am leaning towards going to. Any and all info/advice is appreciated. The key here is "least expensive but will still work". I have bus rear suspension, wide 5 drums, shot buggy cylinder as is all the lines and wheel cylinders. Looking at going to: '86 S10 blazer rotors (10.5" OD, 2.054" OAH, and ID of 6.53") @ $28.99 each, S10 front calipers @ $24.99 each, and the mastercylinder as well. Plans are to machine the drum surface off, use a dial indexing plate to index the holes for the rotor to mount on the back side of the turned-down drum, then use the backing plate mount tabs for an adapter plate to mount the calipers on. Sound do-able? Had looked at the '98 or so jeep front rotor, was a little bit bigger and taller. 11.02" OD, 3.095" OAH, and 6.89" ID. OAH---Over All Height |
|
| Author: | MadMike [ Wed Feb 18, 2009 7:56 pm ] |
| Post subject: | Re: Heading over to the disc side..... |
Stock bus arms? |
|
| Author: | nickschlemer [ Wed Feb 18, 2009 8:09 pm ] |
| Post subject: | Re: Heading over to the disc side..... |
You ever go over to www.shoptalkforums.com they can help you aswell.. |
|
| Author: | eggman [ Wed Feb 18, 2009 8:32 pm ] |
| Post subject: | Re: Heading over to the disc side..... |
Yes,Mike, stock bus arms. Will check out that forum as well, Nick. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|